Heavy equipment and mining yards run on concrete that can carry the gear and survive the mess. Oshawa Concrete builds wash bays with proper oil-water separators, fuel station pads sized for tanker trucks, and heavy-load slabs poured thick and reinforced for wheel loaders, dozers and haul trucks. Every project is engineered for the equipment that actually parks on it, with a free written estimate to start.
Why Heavy Equipment Concrete Is a Different Animal
A slab in a heavy-equipment yard takes loaders, dozers, haul trucks and constant brake forces, plus oil, grease, fuel and pressure washing. A standard industrial slab does not last six months under that.
Equipment wash bays are built with the slope and the oil-water separator pit that captures runoff so it never enters storm drains, and the chemistry-resistant surface that handles the cleaners and the grime.
Fuel station concrete is poured for tanker turning loads and the spill-containment around the dispensers, and the rest of the yard is sized for the equipment that crosses it daily. It is the same discipline as our warehouse and manufacturing floors, scaled up to the equipment.
Recent work
How it works
How We Pour a Heavy Equipment Yard in Oshawa
Map the yard and loads
We walk the yard, confirm the equipment that crosses each area, parking, traffic, wash and fuelling, and engineer slab thickness and reinforcement to those specific loads.
Excavate and drain
Sub-bases are excavated and compacted, slopes are set so washwater and rain go where they should, and the separator pit and drainage are built in before any concrete is poured.
Pour for wheel loaders
Slabs are placed thicker and reinforced more heavily than a standard industrial pour, with control joints laid out where the equipment will actually cross them.
Install the separator and seal
Oil-water separators are set, the surface is sealed against fuel and chemistry, and the yard is handed back with the date each area carries equipment.
Wash bays and fuel pads
Wash Bays and Fuel Stations Done Right
An equipment wash bay is a small environmental project as much as a concrete one. The slab has to slope to a trench, the trench has to feed an oil-water separator, and the surface has to take the cleaners that come off a haul truck.
A fuel station concrete pad is built for spill containment, with curbs and slopes that direct any drip back to a contained drainage point, and a surface that holds up to fuel exposure without softening or cracking. Both jobs lean on the same engineering as our concrete pumping and ready mix supply work.
Wash bays, fuel pads, separators and yard slabs for heavy equipment operations in Oshawa.
Yes. An equipment wash bay includes the sloped slab, a trench drain, and an oil-water separator pit sized for the wash volume, so washwater is captured and treated before it can enter a storm drain.
Yes. Fuel station concrete is built with containment curbs, slopes that direct drips back to a contained drain, and a surface chemistry that resists fuel without softening, so a spill is contained and cleaned, not absorbed.
Thicker than a standard industrial pour, sized to the specific equipment that crosses or parks on it. We engineer slab thickness, reinforcement and joint spacing to the actual wheel loads and brake forces, not a generic spec.
Yes. We phase the work area by area, pour and cure one zone while equipment uses another, and coordinate around shifts and weather windows so the yard keeps running.
Yes. We grind back spalled and cracked areas, address the cause, often base failure or joint damage from heavy loads, and rebuild the surface so it carries equipment again instead of failing the same way.
Client reviews
What Oshawa Heavy Equipment Operators Say About Their Yard Concrete
Wash bay slab with a proper separator. The runoff is contained the way our environmental plan promised, and the slab handles the wash chemistry without softening.
V. A.
Mining fleet operations
★★★★★
Poured thick for our wheel loaders and brakes. A year of full-day operations and the joints have not chipped at the corners, which is where the old yard went first.
D. G.
Heavy equipment yard manager
★★★★★
Fuel station pad with containment curbs and the right slope. A spill went exactly where they said it would, into the contained drain, not toward the storm system.
R. O.
Fleet maintenance lead
★★★★★
Phased the yard rebuild around active operations. We never lost a day of equipment access and the new concrete is engineered, not just guessed.
B. N.
Site supervisor
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Oshawa.
Wash bay, fuel pad or a full yard rebuild, tell us the equipment that crosses it and we will engineer the slab and put it in a written, itemised quote.
